Alternator 37300-3C531，373003C531 37300-3C531，373003C531 37300-3C531，373003C531 37300-3C531，373003C531 FOR Hyundai Kia

The installation steps for the Hyundai-Kia 13.5V generator are similar to those for general car generators, but attention must be paid to its specific matching and setting requirements. The following are the specific installation steps and precautions: Installation Steps •  Preparation Work: Confirm that the generator model matches the vehicle and check the battery status. Prepare tools such as wrenches, torque wrenches, voltmeters, and OBD testing equipment. Disconnect the negative cable of the vehicle's battery to avoid short circuits during installation. If the power is off for a long time, a memory saver can be used to back up the on-board system settings.  •  Removing the Old Generator: Open the engine hood and locate the generator. Use a wrench to loosen the generator belt tensioner and remove the belt. Disconnect the electrical connections of the generator, carefully pull out the wire plugs, and mark the position of each plug to ensure correct installation. Loosen the generator's fixing screws, usually there are two upper and lower fastening screws, loosen and remove them with a wrench or socket, then take out the old generator.Install the new generator: Place the new generator in the original installation position, ensure the mounting holes are aligned, and initially secure it with fixing screws, but do not fully tighten them. Connect the generator's cables, correctly plug the plugs back into their previously marked positions, and ensure the connections are firm.  •  Install the drive belt: Adjust the belt tensioner, correctly install the belt onto the generator's pulley, and ensure the belt is properly seated with appropriate tension. Generally, it is appropriate that the middle of the belt can sink 10-15mm when pressed with a finger.  •  Initialization and calibration: Connect the vehicle using an OBD detector, enter the vehicle control system, find the "Generator Settings" or "Electrical System Initialization" option, and input the parameter information of the new generator, such as output current. Enter the BMS (Battery Management System) module for calibration to ensure the system can correctly identify the battery and charging status.  •  Inspection and testing: Reconnect the negative cable of the battery. Start the vehicle and check the working status of the generator, including whether the charging indicator light is off and whether the voltage is normal, with the normal range being 13.5-14.5V.

NotesAccessory Selection: Try to choose original or authorized brand generators to ensure compatibility and reliability.Cleaning Work: Ensure that cable connectors and the generator surface are clean during installation to avoid poor contact.Operation Specifications: Strictly follow the maintenance manual and do not operate arbitrarily on your own.Tool Usage: Use OBD detectors and matching tools that meet the vehicle's technical requirements to avoid operation failure.

References：The content you provided regarding the installation of the Hyundai-Kia 13.5V generator does not have a clear single source. However, based on its content characteristics and expression style, it is likely compiled by integrating information from automobile repair manuals and some professional automotive repair websites. From the content perspective, some steps and precautions are quite similar to the relevant content on the Qiche Dashi (Auto Master) website. For example, the content mentioned in the installation steps about using an OBD detector for initialization and calibration has similar expressions in multiple articles on Qiche Dashi about Kia generator installation, such as those involved in Abstract 1, Abstract 6, Abstract 9, and Abstract 10. But the overall content is not entirely equivalent to any specific article; it may be the integration and sorting of information from multiple sources.