clutch release bearing 41412-49650 41412-49670 VKC3728 ADG03316,41412-49600,58TK3701 990114 500110960,41412-49660 4141249650,4141249670,VKC3728 FOR hyundai D4BH ，Jianghuai G4JS, Kia D4CB

Vehicle Model / Bearing Type Main Installation Steps Key Points Tool Recommendations

JAC iEV Front Wheel Hub Bearing1. Chock the vehicle, remove the decorative cover and dust cover 2. Loosen the tire nuts, lift and remove the tire 3. Remove the braking components and hub 4. Clean the bearing position and journal 5. Check the fit clearance (≤0.10mm) 6. Apply grease, install the bearing and hub 7. Tighten the nut to the specified torque 8. Reinstall the braking components, tire, etc. - Grease must fill the bearing cavity - Replace the bearing if the clearance is too large - Check the rotational flexibility and axial clearance after installation Jack, socket wrench, bearing puller, torque wrench

Kia K3 Front Wheel Hub Bearing1. Lift and remove the tire 2. Remove the brake caliper and brake disc 3. Remove the wheel speed sensor, steering knuckle bolts, etc. 4. Remove the old bearing with a puller or press 5. Press in the new bearing (only apply pressure to the outer ring) 6. Reinstall the axle head, replace with a new nut and rivet the edge 7. Install the dust cover and braking components - It is strictly forbidden to apply pressure to the inner ring - The nut must be replaced and riveted securely - For anti-lock braking system (ABS) models, pay attention to the sensor direction Press, double-disc puller, circlip pliers, opener

Kia Soul Crankshaft Main Bearing1. Thoroughly clean the cylinder block, crankshaft and bearing cap 2. Install the upper bearing (oil groove facing up) 3. Install the thrust bearing (3rd journal, oil groove facing outwards) 4. Position the crankshaft, install the lower bearing and bearing cap 5. Tighten the bolts in sequence and at the specified angle - Main bearing bolts are for one-time use - Align the bearing oil groove with the oil hole - Check the crankshaft end play after installation Torque wrench, angle gauge, cleaning tools

for reference only

General Installation Precautions

Cleaning: The installation site should be free of oil stains and impurities. If necessary, clean it with a cleaning agent and compressed air.

Lubrication: Use high-temperature resistant grease for hub bearings and apply clean engine oil for engine bearings.

Press-fitting Direction: Press the outer ring for hub bearings and the inner ring for the axle head to prevent damage to the rolling elements.

Anti-loosening Measures: Tighten the axle head nut to the specified torque and use riveting edges or lock washers to prevent loosening.

The installation methods and precautions for JAC and Kia bearings mainly come from the original factory maintenance manuals, official technical documents of the brands, and authorized technical service platforms. These are the most authoritative sources of information that match the vehicle design.
for reference only